NETGEAR VMB3500 - Insert Batteries Into Your Cameras; Sync Your Cameras With the Base Station; Position Camera Near Base Station

98
Insert Batteries Into Your Cameras
a. Unlock the battery
compartment by
sliding and holding the
latch.
b. Slide the battery door
back and lift it to
open the compartment.
4
SYNC
Ethernet
Reset
DC
Note: Cameras must be synced one at a time.
a. Bring the camera within 1 to 3 feet (30 to 100 centimeters) of the base station.
c. Insert two batteries
near the back of the
camera.
d. Insert two batteries
near the
compartment hinge.
e. Close the
battery door.
Sync Your Cameras With the Base Station
5