Modem
Ethernet cable ( ) to your modem,
Step 2:
Connect one end of the yellow
and the other end to the Internet port
on your router.
Step 6:
Open a browser.
Step 4:
Step 3:
Plug in, then turn on your modem.
Wait approximately 2 minutes
until your modem turns on.
If your modem has a battery backup,
first remove and reinsert the battery
before connecting your
modem to power.
N600 Wireless Router
(not included)
Laptop or desktop
computer
N600 Wireless Router
Package Contents:
N600 Wireless Dual Band Gigabit Router
Premium Edition
WNDR3800
Installation Guide
Power adapter
Ethernet cable
Power On/Off
If the Web page does not display,
close and re-open the browser
the address bar, or check the
“Troubleshooting” section on
the back of this installation guide.
(with stand attached)
Connect the power adapter to the
router, then plug it into an outlet.
Wait for the 2.4 GHz LED ( )
to turn on.
If none of the LEDs turn on, make sure that
the Power On/Off button is in the ON position
(pushed in).
Attach the stand to the router:
1. Place the stand on a level surface.
2. Slide the router onto the stand.
2.4 GHz
Step 1:
Unplug the power
to turn off your modem.
Step 5:
Connect the router
to your computer.
Use another Ethernet cable to establish
a wired connection as shown in this diagram.
Optionally, connect wirelessly by using the
preset wireless security settings
located on the bottom label.
Slide-on
router stand
DSL
or Cable
Internet
2.4 GHz
5 GHz
and enter http://routerlogin.net in
To Next Page
Need help?
General
