(not included)
Power On/Off
Step 2:
Connect one end of the
yellow Ethernet cable
Step 3:
Plug in the power to
turn on your modem.
Step 6:
Open a browser.
Step 5:
Connect your computer
to the router ( ).
Use another Ethernet cable to
establish a wired connection
as shown in this diagram.
Optionally, connect wirelessly
by using the preset wireless
security settings, located on
the bottom label.
Step 4:
Connect the power adapter to the
router, then plug it into an outlet.
If none of the LEDs light, make sure
that the Power On/Off button is in the
on position (pushed in).
N750 Wireless Router
Laptop or desktop
computer
N750 Wireless Router
Package Contents:
N750 Wireless Dual Band Gigabit Router
WNDR4300
Installation Guide
Power adapter
Ethernet cable
Power On/Off
Step 1:
Unplug the power
to turn off your modem.
to your modem, and the
other end to the Internet
port on your router.
Wait approximately 2 minutes
until your modem turns on.
If your modem has
a battery backup,
first remove and reinsert
the battery before connecting
your modem to power.
Modem
DSL
or cable
Internet
Wait for the 2.4 GHz LED ( )
2.4
GHz
to light.
If the web page does not
display, close and reopen
the browser, then enter
in the address bar, or
check the “Troubleshooting”
section on the back of
this installation guide.
http://www.routerlogin.net
Premium Edition
To Next Page
Need help?
General
Weight and Dimensions
