Wait approximately 2 minutes
until your modem turns on.
If your modem has a battery backup,
first remove and reinsert the battery
before connecting your
modem to power.
Ethernet cable
Step 1:
Unplug the power
to turn off your modem.
Step 2:
Connect one end of the yellow
Ethernet cable ( ) to your modem,
and the other end to the Internet port
on your router.
Plug in, then turn on your modem.
Step 3:
Step 6:
Step 4:
Connect the power adapter ( )
to the router, then plug it into an
If none of the LEDs turn on, make sure that
the Power On/Off button is in the ON position
(pushed in).
outlet. Wait until the wireless LED
turns solid blue.
Step 5:
Connect your computer
to the router.
Use another Ethernet cable to establish
a wired connection as shown in this diagram.
Optionally, connect wirelessly by using the
preset wireless security settings
located on the bottom label.
Open a browser.
If the Web page does not display,
close and re-open the browser
and enter http://routerlogin.net in
the address bar, or check the
“Troubleshooting” section on
the back of this installation guide.
Laptop or Desktop
Computer
To Next Page
Need help?
General
