To Next Page
E
Elizabeth HuffJul 26, 2025
What to do if the Push 'N' Connect (WPS) push-button blinks after setting WPS security on NETGEAR WNR1000v3 - Wireless- N Router?
- PPatrick MartinezJul 26, 2025
If the Push 'N' Connect (WPS) push-button blinks after setting WPS security, ensure that you are using the push-button correctly. Make sure you have not pushed the push-button after disabling the WPS function. Also, verify that you push the WPS button on the client device within 2 minutes after the WPS button on the router is pushed.
General
