EasyManuals Logo

NETGEAR WNR1000v3 - Wireless- N Router User Manual

NETGEAR WNR1000v3 - Wireless- N Router
130 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #114 background imageLoading...
Page #114 background image
Wireless-N 150 Router WNR1000v3 User Manual
Troubleshooting 7-5
v1.0, February 2010
2. Make sure you have not pushed the push-button after disabling the WPS function (you logged
into the router and disabled this previously).
3. Make sure you push the WPS button on the client device within 2 minutes after the WPS
button on the router is pushed.
For more information on WPS, see “Using Push 'N' Connect (Wi-Fi Protected Setup)” on
page 2-13.
Login Problems
If you are unable to log in to the wireless router, check the following:
If you are using an Ethernet-connected computer, check the Ethernet connection between the
computer and the router as described in the NETGEAR Wireless Router Setup Manual.
Make sure you are using the correct login information. The factory default login name is
admin and the password is password. Make sure that the Caps Lock is off when entering this
information.
Make sure your computer’s IP address is on the same subnet as the router. If your are using the
recommended addressing scheme, your computer’s address should be in the range of
192.168.1.2 to 192.168.1.254. Refer to your computer’s documentation or see “Preparing
Your Network” in Appendix B for help with configuring your computer.
If your router’s IP address has been changed and you don’t know the current IP address, see .
http://www.routerlogin.net.
Make sure your browser has Java, JavaScript, or ActiveX enabled. If you are using Internet
Explorer, click Refresh to be sure the Java applet is loaded. Try closing the browser and
reopening it again.
If you are attempting to set up your NETGEAR router as an additional router behind an
existing router in your network, consider replacing the existing router instead. NETGEAR
does not support such a configuration.
Note: If your computer cannot reach a DHCP server, some operating systems will
assign an IP address in the range 169.254.x.x. If your IP address is in this
range, verify that you have a good connection from the computer to the router,
then restart (reboot) your computer.

Table of Contents

Other manuals for NETGEAR WNR1000v3 - Wireless- N Router

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the NETGEAR WNR1000v3 - Wireless- N Router and is the answer not in the manual?

NETGEAR WNR1000v3 - Wireless- N Router Specifications

General IconGeneral
WiFi Technology802.11n
WiFi SpeedUp to 150 Mbps
Frequency Band2.4 GHz
Power Supply12V DC, 0.5A
SecurityWPA, WPA2
Weight0.44 lb (0.2 kg)
Ethernet Ports4 x 10/100 Mbps LAN, 1 x 10/100 Mbps WAN
Dimensions173 x 128 x 28 mm

Related product manuals