Netio PowerBOX 4KE - Package Contents; LED and Button Functions

3
Package contents:
 NETIO PowerBOX 4Kx device
 Quick Installation Guide (QIG)
 WiFi Antena (exclusively for PowerBox 4Kx – WiFi
variant only)
Status / control indication
1) 1x RJ45 LAN connector
2) RJ45 LEDs – device states (yellow and green)
3) Multifunction “TGL/RESET” button
4) M2M activity LED (red)
5) Connector for WiFi antenna
LED and button functions
OUTPUT LEDs
RJ45 – green
Network Link (lit) + Activity (flashes)
RJ45 – yellow
1x flash when the device starts
3x flash when the internal system
restarts
M2M (red)
Blink when some M2M communication is
in progress
TGL/RESET button
Switching all outputs
Output test:
Press the TGL button 3x rapidly.
– If any of output is On (1) -> Off (0).
– If all outputs are Off (0), All outputs ->
On (1).
Restoring factory defaults
- Disconnect the device from the power.
- Press and hold the RESET button.
- Connect the device back to the power
grid (button is pushed) and wait at least
10 seconds until the yellow LED on the
RJ45 jack flashes 3 times,
- release the RESET button.
3
2
1
4
5