9
Static IP (no DHCP server available on the network)
1) Connect the device to LAN, power and switch it on.
2) Wait at least 30sec and then press and hold the “TGL/RESET” button for min
10sec. until yellow status LED flashes.
3) The device switches to the “Static IP mode” with IP address 192.168.1.78
4) Open the WEB interface using http://192.168.1.78 and log in from computer
connected to the same network (or directly to device) and with IP from the same
subnet (e.g. 192.168.1.10 mask 255.255.255.0).
5) Go to Settings / Network Configuration and select “Set static IP address”, set up
IP, mask, GW and click “Save Changes”. If not modified and not saved by
clicking “Save Changes” the device will use DHCP after the next restart (power
off/on).
WEB interface
The default username / password combination is admin / admin.
To Next Page
Loading...
