ADSL2+ Modem Router User Manual
70
Direction Select: Select the router interface. You can select LAN or WAN. In this example, WAN is
selected.
WAN Setting: You can choose Interface or IPv6 Address.
WAN Interface: Choose the interface that permits data packets from WAN to access the router.
IP Address: Enter the IPv6 address on the WAN. Only the IPv6 address that is in the same
network segment with the IPv6 address on the WAN can access the router.
Services Allowed: You can choose the following services from WAN: Web, Telnet, FTP
, TFTP, SNMP, or PING. You can also choose all the services.
Add: After setting the parameters, click it to add an entryto the Current IPv6 ACL Table.
Reset: Click it to refresh this page
4.4.5 DoS
DoS
The router provides a protection of Denial of Service attack.
To Next Page
Loading...
Need help?
General
