How to restore Netis DL4422 Modem Router to default settings?
To restore your Netis Modem Router's configuration to its default settings: with the router powered on, use a pin to press and hold the Default button on the rear panel for 8 to 10 seconds before releasing it. The router will reboot, and all configurations will revert to factory default.
What to do if my Netis DL4422 Modem internet cannot be accessed?
If your Netis Modem internet cannot be accessed, verify that the hardware connections are correct, referring to the “Hardware Connection” step. Log in to the web management page of your Netis Modem Router and ensure you've input the correct network parameters, contacting your ISP to confirm the VPI/VCI, Connection Type, Username & Password. If issues persist, restore your Modem Router to its factory default settings and retry the “Wizard”.
ISP-provided network parameters required for setup.
Configuring PC's network settings to obtain IP automatically.
Opening a browser and navigating to the router's IP address.
Step 1: Configuring WAN connection type (ATM/PTM) and parameters.
Choosing the connection mode (Bridge, IPoE, PPPoE, etc.) as per ISP.
Step 2: Configuring wireless network name (SSID) and security.
Step 3: Reviewing and applying all configured settings.
Resetting the router to its original configuration using the reset button.
Steps to diagnose and fix problems with internet access.
Information regarding RF exposure limits and operating conditions.
Details on compliance with FCC Part 68 for telephone network connections.
To Next Page
General
