ADSL2+ Modem Router User Manual
85
4) Run the ipconfig command in the windows system to check whether the IP address, subnet
mask, and default gateway have been assigned by DHCP.
5) Reset the ADSL Modem to factory default configuration if necessary.
T5．What related parameters are required when you want to access the Internet by ADSL2+
Modem Router?
1) Dial user: Connection type, User name, Password, Value of VPI/VCI, Encapsulation mode.
2) Static IP user: Connection protocol, WAN IP Address, Subnet Mask, Gateway, Value of VPI/VCI,
Encapsulation mode and so on.
T6. Have completed all configurations, but can’t dial through computer
1) Check the indicator of DSL and Internet. It should be acting normally.
2) Check the value of VPI/VCI, Encapsulation mode and so on, and whether you need to install
the dial software, such as Winpoet, Enternet.
3) The PPP dial procedure is inside the product, so you will not need to use the dial software if
your protocol is PPPoA or PPPoE. ADSL Modem will connect automatically.
4) You can check whether your ADSL Modem succeeds in connection or not with PING
command.
T7. Why the wireless stations cannot connect to the Modem Router?
1) Make sure the ‘Enable Wireless Router Radio’ is checked.
2) Make sure that the wireless stations' SSID accord with the Router's SSID.
3) Make sure the wireless stations have right KEY for encryption when the router is encrypted.
4) If the wireless connection is ready, but you can’t access the router, check the IP Address of
your wireless stations.
T8. How to assign a static IP for your computer?
1) For Windows XP, open the control panel, double click network connections, choose local area
connection, right click it and click properties, check ’use the following IP address’ and ‘use the
following DNS server addresses’, enter the network parameter.
2) For Windows 7,open the control panel, double click network and sharing center, click change
adapter settings, choose local area connection, right click it and go to properties, check ‘use the
following IP address’ and ‘use the following DNS server addresses’, enter the network parameter.
To Previous Page
Loading...
Need help?
General
