NETSPA ASPEN - Page 27

27
EN
Press the lter button to activate the water ltration. The green indicator light will
turn on when the ltration system is activated.
Note:
- If massage function is on, the ltration can’t be activated.
Press the heating button to activate water heating and ltering system at the
same time. The green indicator light of lter and red indicator light of heating will
turn on at same time
The pump does not stop heating until the current water temperature reaches the
set temperature (The red light ashes once the temperature is reached). The
heating system will restart after the current water temperature drops 2°C below
the set temperature automatically.
Maximum heating temperature: 42°C (107°F)
Important :
After 150 cumulative hours of ltration operations, an audible alarm will
sound and the LCD display will show the characters CHG, followed by FIL,
to remind you to change and clean the lter. You can hold the ltering but-
ton 5 seconds to turn o the buzzing. The ltering system will turn o, you
can press the button to active the ltering system again.
Note :
- The heating system is dependent on the ltration system and it can operate without.
- After turning off the heating system, the ltration system will still work.
- If the massage function is active, the ltration and heating functions cannot be activated.
- The engine block is designed to operate 24 hours a day.
- The spa cannot be connected to a programmer because of its electrical protection.
4.3. Pool cover and security
After each use, the control panel must be locked and the pool must be coated with its
top cover and it must be attached to the base protector with the safety buckles.
Each safety buckles has a lock system ; closed buckle, the latch in up position locks
the buckle, the latch in down position unlocks the buckle.
The top cover keeps the heat from the water and secures the pool.