ASSEMBLING THE PRODUCT
EXCHANGING THE WORKING HEAD OF THE HEDGE TRIMMER OR
CHAIN SAW
Push part 4, turn part 3 and pull part 1. Connect the needed head as shown
in the last section.
You may need to rotate the pole from side to side until it locks into place.
WARNING! Failure to lock the pole as directed could result in injury or
death.
This device is only made for cutting and trimming hedges, bushes, and
shrubs around your home. This tool is designed for adults. 16+ can use with
supervision.
This hedge trimmer should only be connected to a single-phase AC socket
outlet. Ensure the mains voltage matches the voltage indicated on the rating
plate.
STOPPING AND STARTING THE DEVICE
Connect the hedge trimmer plug to the power supply.
To start the blade movement, push the lock-off button and then pull the
switch trigger. To stop, release the switch trigger.
Note: Only use an approved outdoor extension cord when operating this
tool.
Grasp the telescopic pole with your left hand the rear handle with your right.
To Next Page
Loading...
