Maintenance
YoushouldinspecttheairfilterintheAirCompressorAssemblytoseeifit
isexcessivelydirty.Ifitisdirty,followthestepsbelow
toreplaceit.
1.Unplugthespraygun.Remove
thefiltercoverwithatool
(suchasaflatscrewdriver)
2.Removethedirty
filtersandreplace
withnewones.
3.Securethecoverbackontotheturbine.
Neveroperateyourunitwithouttheairfilters.Dirtcould
besuckedinandinterferewiththefunctionoftheunit.
Troubleshooting
Problem
A.Littleornomaterialflow
B.Materialleaking
C.Atomizationistoocoarse
D.Sprayjetpulsates
E.Patternrunsorsags
F.Toomuchoverspray
G.Patternisverylightand
splotchy.
Cause
1.Nozzleclogged.
2.Suctiontubeclogged.
3.Materialvolumesettingturnedtoolow(‐).
4.Suctiontubeloose.
5.Nopressurebuildupincontainer.
6.Airfilterclogged.
1.Nozzleloose.
2.Nozzleworn.
3.Nozzlesealworn.
4.Materialbuild‐uponaircapandnozzle
1.Viscosity
ofmaterialtoohigh.
2.Materialvolumetoolarge.
3.Materialvolumesettingtoohigh(+).
4.Nozzleclogged.
5.Airfilterclogged.
6.Toolittlepressurebuild‐upincontainer.
1.Materialincontainerrunningout.
2.Airfilterclogged.
1.Applyingtoomuchmaterial.
1.Guntoofar
fromsprayobject.
2.Toomuchmaterialapplied.
1.Movingthesprayguntoofast
Solution
1.Clean.
2.Clean.
3.Increasevolumesetting(+).
4.Insert.
5.Tightencontainer.
6.Change.
1.Tighten.
2.Replace.
3.Replace.
4.Clean.
1.Thin.
2.Decreasevolumesetting(‐).
3.Decreasevolumesetting(‐).
4.Clean.
5.Change.
6.Tightencontainer.
1.Refill.
2.Change.
1.Adjust
materialfloworincrease
movementofspraygun.
1.Reducedistance.
2.Decreasevolumesetting(‐).
1.Adjustmaterialflowordecrease
movementofspraygun.
7
filters
To Next Page
Loading...
