8
Additional security warnings
Power tool fasteners.
Careless use of tools can cause accidental fire and personal injury to fasteners. Don't point the tool at
yourself or anyone nearby. Accidental triggering can cause firmware to fall off and may cause damage.
Do not start the tool unless it is firmly against the work piece. If the tool is not in contact with the work
piece, the fastener may deviate from your goal.
Make sure the power switch is in the correct position and keep the tool disconnected from the power
supply when the fastener studs. If the tool is charged and in the on position or inserted and connected to
its charger while removing the stuck firmware, it may accidentally activate the tool.
Remove stuck fasteners with care. Point the tool away from yourself or others. The mechanism may be
in a compression state and the fastener may be forced to release while attempting to release the jammed
state.
Do not let this tool fix the cable. This product is not suitable for cable installation. It may damage the cable
insulation and cause electric shock or fire hazard.
Specific security rules
1. When the tool may come into contact with hidden wires or its own wires, hold the tool through the
insulating clamping surface during operation. Contact with "live" wires can also cause the exposed metal
parts of the cutter to "live" and vibrate the operator.
2.Know your power tools. Read the operation manual carefully. Understand its applications and
limitations, and the specific potential dangers associated with this tool.
3.Wear rimmed safety glasses. Ordinary glasses have only impact lenses. They're not safety glasses.
Following this rule will reduce the risk of eye injuries
4.Protect your hearing. Wear hearing protection during long hours of operation. Following this rule will
reduce the risk of serious personal injury.
5.Protect your lungs. Wear a mask or dust mask. Following this rule will reduce the risk of serious person-
al injury.
6. Do not abuse the charger cable. Do not carry tools with the charger cord. Do not yank the wire away
from the socket. Keep the charger wire away from heat, oil and sharp edges, and moving parts.
7. Do not attempt to change the tool, your product has tested cycle time. He was designed to function at
this speed to the full. Any unauthorized alteration or use may result in dangerous circumstances and
cause serious bodily injury .Automatic failure warranty for unauthorized modification of parts or tools.
8. Replace parts with original parts only.
9. Use appropriate charging equipment. During charging, the tool should always be supplied with a
residual current device rated at or below 20ma.
To Previous Page
Loading...
