Need help?Do you have a question about the Neunaber ICONOCLAST and is the answer not in the manual?
General| Type | Speaker Emulator |
|---|---|
| MIDI | No |
| USB | No |
| Current Draw | 100mA |
| Inputs | 1 x 1/4" |
| Outputs | 2 x 1/4" |
| Power Supply | 9V DC |
Connect a standard 9V DC or 12V DC, 100 mA or greater, center-negative pedal power supply.
Details on the 3.5mm stereo headphone output and its capabilities.
Information about connecting to a computer via micro-B USB cable.
References diagrams for typical connection scenarios.
Details on using the mono outputs with TS or TRS cables.
Details on using the mono input with a TS cable.
Details on using the stereo outputs with TS or TRS cables.
Details on using the stereo input with a TS cable.
Details on using the stereo outputs with TS or TRS cables.
Details on using the stereo inputs with TS cables.
Details on using TRS stereo outputs with TS or TRS cables.
Details on using TRS stereo input with a TRS stereo cable.
Details on output connections for direct amp interface.
Details on input connections for direct amp interface.
Details on output connections for amp interface with effects.
Details on input connections for amp interface with effects.
Controls the headphone output volume independently of main outputs.
Explains the unique tone shaping controls for guitar speaker emulation.
Visualization of frequency response and noise gate transfer function.
Allows modification of low knob behavior, impedance curves, and gate parameters.
Includes EQ, stereo enhancement, bypass, gain, polarity, and settings management.
Instructions for downloading, connecting, and launching the software.
To Next Page
