Neunaber IMMERSE - Output Jacks and Bypass Operation

Important Note: input/output 1 and input/output 2 should not be used with two
discrete signals (such as two dierent instruments).
The FOOT SWITCH bypasses the eect. The LED lights when the eect is active.
Bypassing the eect does not lower power consumption, because it does not turn
o power to the pedal.
The Immerse Reverberator implements a high-quality buered bypass. The signal
is always buered whether on or bypassed. We chose this type of bypass because
the last output in a pedal chain should be buered, and reverb is typically placed
at the end of a pedal chain.
The OUTPUT JACKS (left side) supply output to another eect pedal, an amplifier,
or eects loop return via standard 1/4” (6.35 mm) phone connectors. The buered
output is capable of driving long cables. If plugging into the input of an amp, you
should use the low impedance (Lo-Z) input if available.
• Output 1 only supplies a summed mono output.
• Both Outputs 1 & 2 supply a stereo output. Using both outputs creates
a stereo signal from a mono input.
• Output 2 only supplies a stereo TRS output.