Need help?Do you have a question about the Neunaber IMMERSE and is the answer not in the manual?
Adjusts the overall reverb level and the tone of the reverb signal.
Controls the reverb tail length and selects the reverb algorithm.
Switches for removing dry signal and selecting bypass modes.
Adjusts parameters unique to the selected reverb effect.
Details on the power adapter input and instrument/effect input connections.
Information on audio outputs, signal types, and the pedal's buffered bypass.
Overview of the updated reverb algorithm with enhanced density and imaging.
Describes the large, open sound characteristic of hall reverb.
Details the bright, diffused sound of physical plate reverb.
Explains the distinctive 'twerp' sound of spring reverb.
Describes reverb effects reminiscent of synth pads.
Combines Wet™ Reverb with an echo effect, detailing mix and delay controls.
Combines Wet™ Reverb with a chorusing-like detune effect.
Details on input/output levels, impedance, frequency response, and distortion.
Specifies voltage, current, and plug type for the power adapter.
Provides the physical size and weight of the reverb pedal.
General| Bypass | True Bypass |
|---|---|
| Input Impedance | 1 MΩ |
| Output Impedance | 1 kΩ |
| Type | Reverb Pedal |
| Inputs | 1 x 1/4" (mono) |
| Outputs | 2 x 1/4" (stereo) |
| Power | 9V DC |
| Algorithms | Wet, Hall, Plate, Spring, Shimmer, Echo, Detune |
| Power Requirements | 9V DC, center negative, 100mA |
| Controls | Mix, Depth, Tone |
To Next Page