Neunaber IMMERSE - Effect Types and Parameters; WET Algorithm

The KILL DRY switch removes the dry signal, leaving only the “wet” (eect) signal.
This should be enabled for parallel eect loops, and disabled for serial (common)
eect loops.
The TRAILS switch changes the bypass mode between normal and trails. Trails
allows the eect to naturally trail o after the pedal is bypassed. With normal
bypassing, the eect is abruptly cut o; however, normal bypassing results in
lower noise while the pedal is bypassed.
EFFECTS
Reverberation (“reverb”) gives your instrument a sense of acoustic spaciousness.
There have been various methods of simulating this eect over the years, several
of which have evolved into their own distinct sounds.
fx level
tone
depth
modulate
WET™
WET™ is an updated version of Neunaber’s renowned algorithm, with shorter
pre-delay, higher initial density and more balanced imaging. (See suggested
settings below.)
adjusts the reverb
level
adjusts the length of the
reverb tail (size of the
acoustic space)
controls the tone of
the reverb only
controls the speed and
depth of modulation in
the reverb
SUGGESTED
SETTINGS