NeurOptics NPi-200 Quick Start Guide

NPi
®
-200
Pupillometer System
Quick Start Guide
Power Up
Initial set-up
1. Connect the NPi-200 Pupillometer Power Supply to the
NPi-200 Charging Station and plug into a power outlet.
The green light at the base of the Charging Station will
indicate power has been established.
2. Place the NPi-200 into its Charging Station. After
powering on, the touchscreen will display a blue
battery icon indicating the NPi-200 is charging. The
battery icon will turn green when fully charged.
3. To modify the date and time, from the main screen,
select the Settings icon and then select
Set Date and Set Time . Follow the prompts
to input the proper date and time using 24 hour
time configuration and select Accept.
Turning On the NPi-200
4.When not in use, the NPi-200 will remain powered ON
when seated in the NPi-200 Charging Station.
If the NPi-200 is not in the Charging Station, to conserve
battery life the Pupillometer will:
• Go into sleep mode after 5 minutes. To turn ON, touch
the screen, push any button, or place in the Charging
Station.
• Power down after 30 minutes.
To Turn On the NPi-200
• Press and hold the button (red circle).
To Get to the Home Screen
• Press LEFT or RIGHT button (green circles).
1
2
4

NeurOptics NPi-200 Specifications

General

Type	Pupillometer
Measurement	Pupil size and reactivity
Resolution	0.1 mm
Accuracy	±0.2 mm
Illumination	Infrared LED
Connectivity	USB
Power Source	Rechargeable battery
Operating Temperature	10°C to 40°C
Technology	Infrared
Pupil Size Range	1.0 to 9.0 mm
Display	LCD
Data Storage	Internal memory
Storage Temperature	-20°C to 60°C
Humidity	10% to 90% non-condensing
Measurement Range	1.0 mm to 9.0 mm