13
Step 8: Switching the controller off
At the end of a session, switch off the controller
using the On/Off Button (to “0“). If you don’t do
this, after 2 minutes, the controller will display
the “Power Off Unit” screen (Fig. c) and will emit
three beeps every 30 seconds to remind you to
switch it off. Should you simply press a screen
b u t t o n t o c l e a r t h i s from the screen, it will appear
again after 2 minutes and the controller will
continue to beep every 30 seconds until the
controller is switched off.
Step 7: Removing the Right Garment
Once the left garment has been removed and
the electrodes covered, repeat the process
with the right leg garment, then pack
everything away until the next session.
Important:
You should only fold
the garments once in
half, which allows the
electrodes to remain
flat between sessions.
Fig. c
English
To Next Page
Loading...
