Nevro HFX TSM3000 - Post MRI Instructions; Resuming Stimulation After MRI

16
For Implanted Patients
(PTRC2300/PTRC2500/PTRC3000)
Post MRI Instructions
Only turn stimulation back ON after your MRI
is complete. Your stimulation needs to stay OFF
until after your MRI.
How to turn stim ON after your MRI
1. To exit Impedance Check Mode, press
the Remote Control ON/OFF Button on the
side of your remote control for 5 seconds
until all lights on your remote control turn OFF.
• When your remote control is turned ON
next, it will return to the normal mode.
2. To turn stimulation back ON, rst turn
your remote control ON using the
Remote Control ON/OFF Button (1) on the
side of your remote control, then press the
Stimulation Start/Increase Button (2) once.
3. You will now see illuminated number levels
indicating stimulation is ON and you can
adjust your program settings as needed.
2
3
1
If you’re using a PTRC2300 remote
control, you will see 3 Programs above
the Program Selection Button.
Do not turn stimulation back ON
until you’ve completed your MRI.
Your stimulation needs to stay OFF
until after your MRI.
Note