24
What to do when you’re
done charging
How to use the charging belt
1. When you’re done charging, you’ll hear
1 long beep and your charger will turn
itself OFF automatically. There is no OFF
button on your charger. Check the device
battery level to make sure the battery is
fully charged (four dots).
2. Use your remote control to check that your
device is turned ON.
3. Plug your charger into the wall socket to
make sure your charger will be ready for
your next charging session.
4. To plug your charger into the wall socket,
connect the power adaptor into the
charger’s Power Adaptor Port, then plug
the power adaptor into the wall socket.
The orange light indicates your charger is
being recharged. Recharging is complete
when the orange light turns OFF.
Once you know where to place the Charging
Coil to achieve a strong connection with your
device, use your charger belt to secure the
Charging Coil’s location on your body before
charging.
1. Place the blue Charging Coil in the pouch
on your charger belt and securely attach
the belt around your waist. Use the hook
and loop near the pouch to secure the
Charging Coil cable.
2. Start charging and move the Charging
Coil until it connects with your device.
3. If you want to be able to move during
charging, insert your charger into the
holster, then clip the holster to your
belt or pants.
4
For Implanted Patients
(CHRG2500)
How to Use Your Charger
To Next Page
Loading...