Need help?Do you have a question about the New Focus 100X and is the answer not in the manual?
General| Brand | New Focus |
|---|---|
| Model | 100X |
| Category | Security Sensors |
| Language | English |
Provides initial steps to operate the photodetector modules, covering setup and basic usage.
Details the procedure to check the module's battery status and DC offset voltage.
Explains how to properly connect the module's microwave output to test instruments.
Guides on aligning the optical fiber for optimal signal transmission.
Provides step-by-step instructions for replacing the internal 9V battery.
Discusses principles of single-mode optical fiber for optimal signal transmission and bandwidth.
Details RF connector types and their frequency range compatibility for optimal connection.
Describes the internal circuitry and components of the photodetector modules.
Details how to check the DC offset voltage to diagnose potential photodiode damage.
Outlines the steps to verify the battery level for troubleshooting.
Describes a simple test to verify the photodetector's basic functionality using CW light.
Explains how to clean the fiber connector to resolve signal issues.
To Next Page