New Holland C237 User Manual

Part number 48068128
1
st
edition English
January 2018
SERVICE MANUAL
Printedin U.S.A.
© 2018 CNH Industrial America LLC. All Rights Reserved.
NewHolland is a trademark registered in the United States and many other countries,
owned or licensed to CNH Industrial N.V., its subsidiaries or affiliates.
L221 / L228
Tier 4B (final)
200 Series Skid Steer Loader
PIN NGM418237 and above; PIN NHM435463 and above
C227 / C232 / C237
Tier 4B (final)
200 Series Compact Track Loader
PIN NGM418237 and above; PIN NHM435463 and above

New Holland C237 Specifications

General

Engine Make	FPT
Bucket Width	72 in
Breakout Force, Lift Cylinder	6, 110 lbs
Bucket Breakout Force	6, 614 lbs (29.4 kN)
Lift Arm Breakout Force	6, 110 lbs

Summary

Link Product / Engine

INTRODUCTION

Foreword - Important notice regarding equipment servicing

Important notice regarding equipment servicing procedures and manufacturer responsibilities.

Safety Rules - Ecology and the environment

Discusses environmental impact and safe disposal of fluids and batteries.

Safety Rules - Personal safety

Outlines precautions for operator and bystander safety during operation and maintenance.

Basic instructions - Loader arm lock and cab tilt procedure - radial lift machines

Steps for securing loader arms and tilting the cab for radial lift machines.

Basic instructions - Loader arm lock and cab tilt procedure - vertical lift machines

Steps for securing loader arms and tilting the cab for vertical lift machines.

Torque - Standard torque data for hydraulics

Provides torque values for hydraulic tube nuts and O-ring boss fittings.

Basic instructions - Shop and assembly

Guidance on shimming, rotating shaft seals, O-ring seals, and sealing compounds.

Protecting the electronic and/or electrical systems during charging and welding

Precautions to avoid damage to electronic systems during charging and welding operations.

Torque - Minimum tightening torques for normal assembly

Lists minimum torque values for metric non-flanged hardware.

Metric Hardware Identification and Grades

Details metric hex head bolts, carriage bolts, nuts, and locknuts identification and grades.

Inch Flanged Hardware Identification and Grades

Details inch flanged hardware, SAE grades, and identification markings.

Inch Lock Nuts - Grade Identification

Describes three optional methods for identifying inch lock nut grades.

Basic Instructions - Video Links

Information on accessing service videos via eTIM or Dealer Portal.

General Specification - Biodiesel Fuels

Details biodiesel fuel types, specifications, usage conditions, and maintenance impacts.

General Specification - Engine Oil Temperatures

Recommends engine oil types based on ambient temperature ranges for Tier 4B engines.

General Specification - Hydraulic Oil

Provides temperature ranges and viscosity recommendations for hydraulic oils.

Product Identification

Locates Product Identification Number (PIN), ROPS plate, and engine serial number plates.

Machine Orientation

Defines directional terms (front, rear, left, right) as seen from the operator's seat.

Engine - 10 Service Section

Engine and Crankcase

Details procedures for draining and managing engine oil for remote and quick-disconnect systems.