SECTION 1 - GENERAL INFORMATION
38. WHEN DRIVING THE LOADER
ON
A ROAD
OR
HIGHWAY, USE WARNING LIGHTS OR
WARNING DEVICES
AS
MAY BE REQUIRED BY LOCAL OR STATE GOVERNMENT
REGULATIONS. HEADLIGHTS, WARNING LIGHTS AND SMV SIGNS ARE AVAILABLE
THROUGH YOUR NEW HOLLAND DEALER.
39. KEEP THE LOADER CLEAN.
DO
NOT ALLOW TRASH, DEBRIS
OR
OTHER ARTICLES TO
ACCUMULATE IN THE
CAB, FLOOR OR FOOT CONTROL PEDAL
AREA
THAT MAY HINDER
SAFE MACHINE OPERATION.
40. NEVER OPERATE THE LOADER WITH ANY OF THE SHIELDING REMOVED.
41. NEVER OPERATE THE LOADER WITHOUT WINDOWS AND/OR SCREENS
IN
PLACE.
42. NEVER EXTEND ANY PART OF THE BODY OUTSIDE OF THE OPERATOR'S AREA.
43. ALWAYS PROPERLY TIE DOWN THE SKID-STEER LOADER TO A TRUCK OR TRAILER
BEFORE TRANSPORT.
44. MAKE SURE
ALL
BYSTANDERS ARE AT A SAFE DISTANCE AWAY FROM THE LOADER
BEFORE STARTING THE ENGINE.
45. DO NOT ALLOW ANYONE NEAR THE LOADER WHILE THE ENGINE IS RUNNING AND THE
LOADER IS OPERATIONAL.
46. WHEN USING THE SKID-STEER LOADER TO CRANE OBJECTS, DO NOT ALLOW ANY
PERSON TO RIDE
ON
OBJECTS BEING CRANED.
47. DO NOT USE THE SKID-STEER LOADER AS A WORK PLATFORM FOR SUPPORTING
MATERIALS.
48. DO NOT LIFT PERSONNEL OR
ALLOW
PERSONNEL
TO
WORK WHILE STANDING
IN
THE
BUCKET
OR ON
OTHER ATTACHMENTS. THIS IS NOT A MAN-LIFT.
OSHA REQUIREMENTS NOW MAKE IT THE EMPLOYER'S RESPONSIBILITY
TO
FULLY
INSTRUCT EACH OPERATOR IN THE PROPER AND SAFE OPERATION OF
ALL
OPERATIVE
EQUIPMENT. BOTH EMPLOYER AND EMPLOYEE SHOULD THOROUGHLY FAMILIARIZE
THEMSELVES WITH THE FOLLOWING SECTIONS.
A
CAUTION!
SOME PICTURES IN THIS MANUAL SHOW SAFETY SHIELDS REMOVED OR OPEN
TO
SHOW
PARTS BEING SERVICED OR FOR CLARITY.
ALL
SHIELDS SHOULD BE CLOSED
OR
REPLACED PRIOR TO OPERATING THE MACHINE.
DANGER!
FASTEN SEAT BELT
BEFORE STARTING ENGINE!
THIS LOADER IS A VERY STABLE UNIT BUT IT CAN BE UPSET IF STOPPED SUDDENLY WHEN
THE BUCKET IS RAISED AND LOADED.
THEREFORE, DO NOT START THE ENGINE BEFORE SECURELY FASTENING THE SEAT BELT,
AND
CARRY THE LOAD LOW.
1-6
Find manuals at https://best-manuals.com
To Next Page
Loading...
