EasyManua.ls Logo

New Holland Speedrower 200 - User Manual

New Holland Speedrower 200
81 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Part number 47698329
1
st
edition English
April 2014
SERVICE MANUAL
Speedrower
®
200
Speedrower
®
240
Self-Propelled Windrower
PrintedinU.S.A.
Copyright © 2014 CNH Industrial America LLC. All Rights Reserved. NewHollandisaregisteredtrademarkofCNH Industrial America LLC.
Racine Wisconsin 53404 U.S.A.

Table of Contents

Questions and Answers

  • P
    Paul MartinAug 13, 2025
    Why is my New Holland Farm Equipment engine overheating?
    • M
      Marcia LynchAug 13, 2025
      If the engine of your New Holland Farm Equipment overheats, several factors could be responsible. It could be due to a faulty water pump, which would require checking and possible replacement, including the gasket. A malfunctioning thermostat should be replaced. Restricted coolant openings in the cylinder head and cylinder groups need washing with specified descaling products. A slack water pump drive belt should be checked and adjusted for tightness, or if equipped, the automatic tensioner setting should be verified. Ensure the coolant level is adequate by filling the radiator and recovery tank to the correct levels. Incorrect engine timing or calibration of the injection pump must be corrected. Lastly, a blocked air cleaner should be cleaned or replaced.
  • P
    paulaliciaAug 20, 2025
    Why is my New Holland Speedrower 200 engine producing black smoke?
    • K
      kingdonaldAug 20, 2025
      If your New Holland Farm Equipment engine is smoking black or dark grey, it could be due to several reasons. The maximum pump output might be excessive, requiring disconnection and adjustment according to the calibration table. There might be an excessive delay or advance on the injection pump, which needs correction. Partially or entirely blocked injector holes necessitate injector replacement or rectification using suitable equipment. A blocked or deteriorated air cleaner needs cleaning or replacement. Loss of compression, due to stuck or worn rings, worn cylinder liners, or deteriorated valves, may require an engine overhaul. Lastly, unsuitable injection hoses or pinched hose ends should be inspected and replaced as necessary.
  • K
    Keith RichardsAug 28, 2025
    Why does my New Holland Speedrower 200 Farm Equipment engine lack power and run irregularly?
    • M
      Megan WilsonAug 28, 2025
      If your New Holland Farm Equipment engine operation is irregular and lacks power, it may be due to incorrect timing of the injection pump, which requires checking and correct setting. Excessive piston wear may also be a factor, necessitating a check or replacement of the injection pump.
  • M
    Ms. Tracy SmithSep 4, 2025
    What does blue smoke from my New Holland Speedrower 200 engine mean?
    • S
      Sharon DavisSep 4, 2025
      If your New Holland Farm Equipment engine is emitting blue, grey-blue, or grey smoke tending to white, it could be due to an excessive delay in the injection pump, requiring correction of the set-up. A faulty injector should be replaced. Leaking oil from the piston rings, caused by glued or worn rings or wearing of cylinder liner walls, may require overhauling the engine.
  • J
    James HernandezSep 8, 2025
    What to do if New Holland Farm Equipment engine doesn't start in cold weather?
    • T
      Taylor GreenSep 8, 2025
      If your New Holland Farm Equipment engine does not start at low temperatures, it is possible that the fuel system is clogged with paraffin crystals due to the use of unsuitable fuel. Replace the fuel with fuel suitable for use at low temperatures and replace the fuel filters.
  • S
    Shannon MartinezNov 16, 2025
    How to troubleshoot a New Holland Farm Equipment engine that won't start?
    • R
      Robert BowenNov 16, 2025
      If your New Holland Farm Equipment engine doesn't start, begin by checking the battery. A dead or faulty battery should be recharged or replaced. Inspect the connections to the battery terminals for corrosion or looseness; clean and tighten them, replacing parts if excessively corroded. Incorrect timing of the injection pump requires checking and correction, possibly by a Bosch dealer. Deposits or water in the fuel tank necessitate cleaning the hoses with compressed air, dismantling and cleaning the injection pump, removing water from the tank, and refueling. Ensure there is fuel in the tank. Check for a faulty starter motor, repairing or replacing it as needed. Also, check for air bubbles in the fuel lines or injection pump, ensuring hoses are intact and eliminating air by unscrewing the ...
  • M
    morgangloriaNov 23, 2025
    What to do if my New Holland Speedrower 200 Farm Equipment engine is knocking?
    • J
      Jocelyn DavenportNov 23, 2025
      If your New Holland Farm Equipment engine is running with abnormal knocking, several issues could be the cause. Faulty operation of injectors requires replacing all injectors. Blocked fuel lines should be dismantled, cleaned, and replaced if severely dented. An incorrect set-up of the injection pump needs correction to ensure injection occurs at the specified angle. Knocking of the crankshaft, due to excessive play on bearings or shoulders, requires rectifying the crankshaft pins and installing smaller bearings, and replacing the thrust half-rings. An unbalanced crankshaft needs alignment checking. Misalignment of rods requires checking individual unit leakage to determine damage location. Noise from piston journals, due to excessive play, requires replacing the piston journal and/or the p...
  • M
    martinmatthewDec 1, 2025
    What causes my New Holland Farm Equipment engine to cut out?
    • A
      Antonio HunterDec 1, 2025
      If your New Holland Farm Equipment engine cuts out, it could be due to several reasons. The idle rpm might be too low, requiring adjustment with the adjustment screw. An irregular flow of the injection pump needs flow adjustment. Impurities or water in the fuel lines require disconnecting and cleaning the hoses with compressed air, dismantling and cleaning the injection pump, removing water from the fuel tank, refueling, and draining the fuel system. A clogged fuel filter needs dismantling and replacement. The presence of air in the fuel and injection system requires checking for cracked hoses or loose unions, replacing worn parts, removing air from the hoses, and deaerating the injection pump and fuel filter. Broken injection pump controls necessitate replacing the faulty parts. Abnormal ...

Summary

INTRODUCTION

Foreword and Dealer Information

Introductory notes, dealer guidance, and company policy for equipment servicing.

General Safety Guidelines

Comprehensive safety rules covering personal, machine, operational, and maintenance practices.

Technical Data and Procedures

Torque specifications, shop/assembly, capacities, lubrication, identification, and contamination.

ENGINE SERVICE

Engine and Crankcase Overview

General specifications and overview of the 6-cylinder turbocharged engine.

Engine Removal Procedure

Step-by-step instructions for removing the engine from the machine.

Engine Installation Procedure

Step-by-step instructions for installing the engine into the machine.

Engine Troubleshooting Guide

Common engine problems, their possible causes, and recommended corrections.

ENGINE FUEL FILTERS

Fuel Filter Bleeding Procedure

Procedure for bleeding the fuel system after filter replacement.

New Holland Speedrower 200 Specifications

General IconGeneral
BrandNew Holland
ModelSpeedrower 200
CategoryFarm Equipment
LanguageEnglish

Related product manuals