Need help?Do you have a question about the New Holland TT4.80 and is the answer not in the manual?
General| Engine Power | 80 hp |
|---|---|
| Displacement | 3.4 L |
| Transmission Type | Synchro Shuttle |
| Transmission | 12F/12R |
| Drive | 4WD |
| Weight | 3000 kg |
| Engine Type | 4-cylinder diesel |
Provides introductory information and important notices for operating and maintaining the tractor.
Details essential safety precautions, warnings, and dangers to prevent accidents during operation and maintenance.
Covers safety precautions for engine startup and general engine maintenance operations.
Details safety for electrical, hydraulic systems, wheels, tires, and component removal/installation.
Covers safety for acids, alkalis, adhesives, sealers, resins, and cyanoacrylates, emphasizing ventilation and protection.
Details safety for isocyanates, antifreeze, battery acids, brake fluids, and general chemical handling practices.
Provides 'Do's' and 'Don'ts' for chemical handling, and safety for corrosion protection materials.
Addresses safety for dusts, electric shocks, exhaust fumes, and fire hazards.
Covers safety aspects of fuels, especially gasoline, and general fire safety precautions.
Details safety for kerosene, diesel fuel, gas cylinders, and workshop tools and equipment.
Covers safety for high-pressure equipment, legal aspects, lubricants, greases, paints, and one-pack materials.
Focuses on safety for solvents, solder, and two-pack materials, highlighting flammability and health risks.
Addresses safety for suspended loads, resistance welding, arc welding, and general welding practices.
Details safety precautions for gas welding, including fire, explosion, and fume hazards.
Details the engine and its crankcase, covering general specifications and components.
Provides detailed technical specifications for the engine, including bore, stroke, power, and various engine block dimensions.
Lists and describes special tools required for engine maintenance and repair procedures.
Provides specifications for the engine crankcase, including crankshaft bearings, crankpin dimensions, and thrust washers.
Details specifications and dimensions for connecting rods, including small and big end bores and alignment.
Provides specifications for pistons, including diameter, clearance, wear, and ring gaps.
Outlines clearances for the dynamic balancer components, such as shaft and bushing clearances.
Provides a general overview of the engine's design, including cylinder head, camshaft, and crankshaft assemblies.
Explains the design and function of intake and exhaust manifolds for balanced heat distribution.
Describes the crankshaft timing gear, its fitting accuracy, and its role in maintaining engine timing.
Details the engine lubrication system, including the oil pump, filter, oil galleries, and lubrication points.
Explains the function of the cooling system, water pump, thermostat, and radiator for engine temperature regulation.
Outlines procedures for engine overhaul and repair, differentiating between operations performed with the engine installed or removed.
Provides a step-by-step guide for safely removing the engine from the tractor, including necessary precautions.
Details the process of safely separating the engine from the front axle, emphasizing lifting and support procedures.
Guides the reinstallation of the engine onto the tractor, including connecting various systems and components.
Lists the steps for disassembling the engine, including removal of major components like the turbocharger and exhaust manifold.
Details the procedure for assembling the engine, covering the installation of components like the fuel filter and alternator.
To Next Page