Power Control
Warning Light
Mode Control
The power control turns the unit on and off.
Condensed water may accumulate in the unit. If
the internal tank becomes full, the Warning Light
will shine and the unit will not operate until the
unit has been drained.
The settings are adjusted with Mode Control
button. A light will indicate which setting is
currently being used.
When cool mode is selected, the indicator light
will shine green. During the cooling mode the
air is cooled and hod air is exhausted to the
outside air through the exhaust tube. Adjust fan
speed air through the temperature to suit your
desired comfort level.
When dehumidify mode is selected, the indicator
light will shine orange. Air is dehumidified as it
passes through the unit, without being in full
cooling mode. The fan will operate in med speed.
Fan speed is not adjustable in dehumidify mode.
The Mode Control has three settings:
Cool Dehumidify Fan
Cooling Mode
Dehumidify Mode
Note : The air exchange hoses must vent
outside the room when using cool mode.
Note : The air exchange hoses must vent inside
the room when using dehumidify mode.
The Fan Speed Control has 3 settings: High,
Medium, and Low.
With machine in fan mode, press timer button to
select number of hours you would like the unit to
run in air conditioning mode until it automatically
shuts off.
With machine powered off , press timer button to
select number of hours until you would like the unit
to automatically start running in air conditioning mode.
Used for adjusting the timer and thermostat.
The default display is room temperature.
In cooling mode, when " " or " " button is pressed,
the set temperature is displayed and may be adjusted.
After 15 seconds the display will revert back to room
temperature. Temperature is only adjustable in cool
mode. The time is adjustable between 1~12 hours.
Note : By pressing both Timer / Temp set buttons at the
same time, the display will toggle between Celsius and
Fahrenheit.
Fan Speed Control
Timer
Timer / Temp set controls
Auto turn off :
Auto turn on :
Fan Mode
When fan mode is selected the indicator light will
shine yellow. Air is circulated throughout the room
with no cooling.
Note: unit does not need to be vented in Fan mode
After switching the air conditioner off, you must wait 3 minutes before switching it back on again.
Warning Light
Power Control
Mode Control
Fan Speed Control
Display Mode Indicators
Display
Timer / Temp
Set Controls
OPERATION
-4-
To Next Page
Loading...