6
http://www.NewAir.com
ASSEMBLY & INSTALLATION
HANDLE ASSEMBLY
Tools Required for Assembly: Phillips screwdriver (not included)
Estimated Assembly Time: 5 minutes
Before installation, attach the handle to the front of the unit with the included
screws. It may be necessary to push aside the rubber seal on the inside of the
door to reveal the screw holes.
Caution: Avoid over-tightening the screws, or you may cause damage to the
unit.
INSTALLATION
This cooler is a freestanding unit and should not be installed inside a cabinet or
other built-in enclosure.
For proper ventilation, allow 5 inches clearance between the back of the unit
and any adjacent walls.
Before operating your wine cooler for the first time, follow these steps:
Clean the interior surface of the unit with lukewarm water and a soft cloth.
Place the cooler on a level surface that will be strong enough to support the
unit when it is fully loaded. To level your cooler, adjust the front feet located
at the bottom of the unit.
Install the cooler away from direct sunlight and heat sources such as stoves,
heaters, or radiators. Direct sunlight may affect the unit’s acrylic coating,
and nearby heat sources can increase electrical consumption. Extreme cold
or hot ambient temperatures may also prevent proper performance.
Please note: this cooler is only designed for home use, and is not designed to
be placed in a garage, or outdoor area.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
