EasyManua.ls Logo

NewAir WCD-200W - CLEANING & MAINTENANCE; Cleaning the Housing; Cleaning the Water Tanks

NewAir WCD-200W
10 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
8
http://www.NewAir.com
5. CAUTION: To avoid burns, avoid direct contact with
the hot water. Never allow children to dispense hot water
without supervision.
CLEANING & MAINTENANCE
Unplug the unit from the electric outlet before performing any maintenance or
servicing the product.
CLEANING THE HOUSING
Use a soft, damp cloth to wipe the body clean. Clean the drip tray and
storage cabinet as needed.
Remove dust from the condenser coils on the back of the unit to improve
efficiency.
Never use strong chemicals, gasoline, detergents, chemically-treated
cloths, or any other cleaning solutions to clean the water dispenser, as
these can all potentially damage the unit.
Never use detergent or chemicals harmful to health when cleaning.
Do not directly spray water on the surface of the product.
CLEANING THE WATER TANKS
To periodically clean the water tanks, follow the procedure described for
“Initial Cleaning” on page 6 of this manual. Hard water may cause mineral
deposits to build up on the interior of the hot water tank, resulting in a
decrease in heating capacity. To remove deposits, fill the hot water tank with
an aqueous solution of 2% citric acid and leave for two hours. Flush system
completely as described above. If the problem persists, contact your dealer or
Customer Service for assistance.
If power supply cord on this device is damaged, it must be replaced with a
special power supply cord that is obtainable at the Service Center of our
company.
If the water dispenser will go unused for more than a few days, it is
recommended that you unplug the unit, remove the water bottle, and
drain the unit completely.