Usage Instructions
Attaching to Your Computer
Connecting Voyager Q to a Macintosh or a Windows computer is a very straight-
forward procedure.
1. Plug the AC power cord into the wall and into the DC transformer.
2. Plug the DC cord into the Voyager Q power receptacle.
3. Connect Voyager Q to your computer via the USB 3.0 connector.
Attaching a Drive
1. Make sure Voyager Q is turned o by pressing the power button until the
blue power LED is not illuminated.
2. Insert your SATA hard drive into the base, as shown below.
3. Press the Power Button to turn Voyager Q on.
3.5” SATA Drive 2.5” SATA Drive
To Next Page
Loading...
Need help?
General