NewLine NT+ Series - Remote Control Pairing


◆
5HPRWH&RQWURO3DLULQJ
If a remote control never pairs with a remote control receiver, just load up the battery, it
will get into pairing mode with LED light on at A side. Then insert the receiver and when
\RXVHHWKH/('OLJKWRႇLWPHDQVSDLULQJVXFFHVVIXOO\
If your remote control had ever been paired with a receiver but you lost it accidentally,
the remote control can be paired with a new receiver referring to the steps:
Step 1:Keep B side upwards and press )Q+ 3 button at the same time for 5 seconds
until LED light on at A side;
6WHS,QVHUWQHZUHFHLYHU:KHQWKHOLJKWÀLFNHUVWULSOHWLPHVDQGRႇLWPHDQVSDLULQJ
successfully. The remote will exit from pairing mode after 80 seconds if no
UHFHLYHULVLQVHUWHGDQGWKH/('OLJKWZLOOEHRႇ
You must keep B side upwards when you are pressing the button, please do not turn it over
during this period.
Note
Keep B side upwards
Long press for 5 seconds
A Side B Side