Tuck air floor under the hull with
the inflation valve facing up.
Make sure that the keel bladder
valve is aligned with the hole in
the air floor.
Tuck under
the lip of the
transom.
Fully inflate
the air floor
to 8 psi.
NOTE: When using the boat for the first time, fully inflate it by attaching the foot
pump to each of the hull chamber valves, one at a time, and when pumping, ensure
that a balance of pressure between the chambers is maintained until the boat has
been fully inflated.
When the boat is fully inflated, unscrew the valves and allow approximately 70%\
of the air to escape. Close valves again, and continue assembling the boat.
ATTENTION! For the rest of the assembly process - the boat should be filled to
approximately 30% air capacity.
Learn more
in the “Air
Pressure
Guidelines”
on page
10.
Seat Installation
Install the seat (or seats) by sliding the seat on
to the seat mounts on either side of the boat.
Slide both sides simultaneously until centered
on the mounts.
The seat will be held securely in place once the
boat is fully inflated.
INSTALL SEAT
- 8 -
To Next Page
Loading...