Unscrew all air valves to deflate
the boat.
Remove the seat.
Remove air floor and deflate.
Using the foot pump as a suction device,
remove excess air from each chamber,
including air floor.
With the boat now flat, fold the back
end cones over the transom. Fold the
hull sides in toward the center. Roll
the transom over itself toward the bow.
Finish inflating thr air chambers one
after the other in order to maintain
equal amount of air.
Install valve caps.
Inflate the keel and screw on valve
cap.
Push two halves of the
oar together with button
aligned with hole.
Push button in and continue
sliding halves together until
the button pops up.
1.
2.
3.
4.
5.
Secure oar to the oar
attachment fixture.
Snap oar into the oar kep
when not in use.
NOTE: DO NOT inflate any chamber to
full capacity at one time.
NOTE: Make sure the plastic stem is in
the lock position. Screw cap on each
valve.
NOTE: The boat should be clean and dry
before rolling up for storage. Remove
any sand and debris.
Finish Inflation
Oar Assembly
Disassembly
- 9 -
To Next Page
Loading...