Newskill Belenor Pro - Plug Detection; Reset to Factory Setting; Code Meaning & Troubleshooting

Plug Detection
Reset to Factory Seing
CODE MEANING & TROUBLE SHOOTING
The function can defect whether the motors are
connected properly.
With this function, you can make the control unit
to factory seing.
1. Once the display shows “E-3” and “rES”, it means the motors are failed to connected with
control unit.
2. Please unplug the main cable, check all connection and make sure all cables are connected
properly, plug the main cable then.
3. Follow the Manual Reset Progress to reset system.
1. Keep pressing "S" until the display shows "FAC".
2. Press "S" again to confirm to store the control system to factory seing.
Code Information Operating
rES Manual Reseing Refer to the progress of Manual Reset.
Ovr Over Load
Remove the load on desktop until it less than
1000N (220 lbs) before further operation
E-2 Anti-Collision Function
It can be used normally aer removing the
obstacle.
Dut Too Frequent Operation
Make the desk rest for 15minutes before further
operation.
E-4
The Height Dierence between
Two Legs Exceed 1 Inch
Stop the operation and reset, refer to Manual
reset
E-3 Check the Connection
Check the cables and ensure they are well
connected, manual reset before re-use
EN