Why is there over spray or too much paint coming from my Newstripe Construction Equipment?
If you're experiencing over spray or too much paint, lower the spray pressure. Turn the spray pressure control knob counter-clockwise several turns, then increase the pressure just until the spray pattern reaches its full width.
What to do if the Newstripe Construction Equipment pump primes and is running, but the gun does not spray?
First, check that the spray control knob is in the spray position. Next, verify that the pressure control knob is turned to high pressure (clockwise until it stops). Be careful not to force it.
What to do if the Newstripe Construction Equipment has an uneven spray pattern or stringing?
If you notice an uneven spray pattern or stringing, try increasing the spray pressure. It's also possible that the spray tip is chipped or clogged. Try reversing the tip and cleaning it.
What to do if the Newstripe Construction Equipment knobs are set correctly, but it still does not spray?
If your knobs are set correctly but the equipment still isn't spraying, check that the trigger lock on the spray gun is pushed to the operating position. Also, make sure the spray tip arrow is pointing towards the ground and that the lifting bar is operating the gun trigger.
What to do if the Newstripe Construction Equipment sprays too little paint?
If you're getting too little paint, increase the spray pressure. The paint may also need to be thinned. Alternatively, you could try changing the spray tip to a larger size.
What to do if all of the above is correct, but the Newstripe Construction Equipment gun will still not spray?
If you've checked everything and the gun still won't spray, turn the spray control knob to the prime position and turn off the engine. Then, pull the trigger to release pressure. Check the spray gun filter and replace it if it's plugged. Finally, restart the equipment.
What to do if pressure is increased, the tip is clean, but the spray is still not correct on my Newstripe Construction Equipment?
If the pressure is increased and the tip is clean, but the spray is still not correct, it may be due to a worn tip, especially if you have sprayed more than 100 gallons. Replace the tip.
What to do if Newstripe Construction Equipment has over spray or too much paint?
If your Newstripe Construction Equipment is spraying too much paint, lower the spray pressure by turning the pressure control valve knob counter-clockwise several turns. To increase the spray pressure, turn it clockwise until the spray pattern reaches its full width.
How to fix an uneven spray pattern or stringing with Newstripe Construction Equipment?
To correct an uneven spray pattern or stringing with your Newstripe Construction Equipment, first, increase the spray pressure. If the issue persists, the spray tip may be chipped or clogged. Try reversing the tip and cleaning it.
What to do if Newstripe Construction Equipment sprays too little paint?
If your Newstripe Construction Equipment is spraying too little paint, try these solutions: increase the spray pressure, thin the paint, or change the spray tip to a larger size.
General safety warnings including injury prevention, safe operation, and handling potential hazards like skin injection.
Specific safety guidelines for using the spray gun, including pressure release and safe handling.
Procedure for starting the engine, engaging the drive, and moving the machine forward.
Steps for adding fluid, preparing the pump, priming, and starting the engine for spraying.
Details on fluid flow, spray position, activating the spray, and adjusting pressure and height.
Regular maintenance for engine oil, transaxle oil, and lubrication of machine components.
Detailed steps for changing the transaxle fluid and filter, including oil type and filter part number.
Troubleshooting common engine starting and running problems, including fuel, oil, and choke issues.
Diagnosing and resolving issues where the machine fails to move or respond to pedal input.
Troubleshooting problems related to the pump not priming or exhibiting air bubbles in the return hose.
Steps to diagnose and fix issues where the spray gun fails to spray paint.
Addressing problems with paint flow, spray pattern quality, and tip performance.
General| Brand | Newstripe |
|---|---|
| Model | NewRider 5000 |
| Category | Construction Equipment |
| Language | English |
To Next Page
