Newteck Wind Pure - Parts and Components; Operation; Control Panel; How to Use the Unit

12
• Alwaysllthewatertankwithcleanwater.Ifitisfull,donottilt(orknock)theunit.
• Theappliancemustnotbeusedbychildrenoranypersonwithreducedphysical,sensoryor
mentalabilities,orwithalackofexperienceorknowledge,unlesstheyarebeingsupervisedby
aresponsiblepersonwhilstoperatingtheunit.
• Pleaseturnothepowerbeforepullingoutthemainsplug.Donotpullonthepowercable,pull
theplugitselftoavoidbreakages,shortcircuits,resorelectricshocks.
• Donothandletheplugwithwethands,asthismaycauseanelectricshock.
• Pleasedisconnectthemainsplugwhennotusingthedevice.
PARTS AND COMPONENTS
OPERATION
Control panel:
• SWING: Oscillation/Movement
• OFF: Stop/Shut-down
• LOW: Lowspeed
• MID: Medium speed
• HIGH: Highspeed
• COOLING: Cold/Cooling
How to use the unit:
1.Toactivatetheairconditioner,pressthebuttonforthedesiredspeed(low-mid-high)anditwill
changetothecorrectposition .
2.Ifyouwanttoactivatetheoscillationfunctiontovarythedirectionofairow,pressSwing .
3.Toturnotheunitandstoptheairow,presstheOFFbuttonanditwillautomaticallyresetits
position .
Cooling Function (humidication):
1.Removethewatertankfromthebackoftheairconditionerandllthetankwithcleanwater.The
waterlevelmustbebetweenthe“MIN”and“MAX”.