Newteck Wind Pure - Ice Packs; Cleaning; Cleaning the Air Filter; Cleaning the Damp Cloth

Italiano
13
2.Youcanaddtheicepackstothewatertankifyouwanttogetcoolerair.Alwaysusewithwater.
Thewaterlevel,includingtheicepacks,shouldbebetweenthe“MIN”and“MAX”.
3.Choosethedesiredspeed(low-mid-high)andtheunitwillchangetothecorrectposition .
4.PresstheCoolingbutton toactivatetheaircoolingfunction.
Ice Packs:
TheIcePacksstaycoldandslowlyabsorbheatfromthewater,thuscoolingthewatertemperature
inthetankandblowingoutcolderair.
• PuttheIcePacksinthefreezerforatleast6hours.
• RemovethewatertankandplacetheIcePacksalongwithwaterinside.
• TwoIcePacksareincludedforuseaccordingtoyourneeds.
CLEANING
• Pleasedisconnecttheunitfromthepowersupplybeforecleaning.
• Donotimmersethecontrolpanelinliquidorwater
• Donotuseabrasiveproducts.
Cleaning the air lter
Inthebackoftheunit,removetheupperscrewandtakeouttheairlterholderusingthetwoupper
grips.Separatethelterfromthedampcloth.
Cleantheairlterwithaneutraldetergentandasoftbrush,itmaybecleanedwithwater,andthen
lefttodry.
Replacethelterandclothintopositionandscrewbackinplace.
Cleaning the damp cloth:
Inthebackoftheunit,removetheupperscrewandtakeouttheairlterholderusingthetwoupper
grips.Separatethelterfromthedampcloth.
Cleanthedampclothwithaneutraldetergentandasoftbrush.Rinsewithwaterandleaveittodry.
Replacethelterandclothintopositionandscrewbackinplace.
ATTENTION:Placetheclothcorrectlyinpositiontoavoidwaterleakage.
Cleaning the water tank:
Cleanthewatertankwithaneutraldetergentandasoftbrush,thenrinsewithwater.
Cleaning the casing:
Ifnecessary,cleanthecasingwithaneutraldetergentandasoftcloth.
ITALIANO
Grazie di aver acquistato il Condizionatore portatile. Si raccomanda di leggere le istruzioni
prima di usare il prodotto e di conservarle per usi futuri.
MISURE DI SICUREZZA
• Vericareilvoltaggioprimadiattaccarel’apparecchioallapresadicorrente.Lapresadeveavere
unacorrentesuperiorea10A.
ALWAYS ASSURE THAT
THE TANK CONTAINS
WATER WHEN USING
THE COOLING
FUNCTION, OTHERWISE
THE ENGINE WILL BURN.