5.3 Recall saved readings
The thermometer can store 32 sets of forehead measurement data.
When the data is full, the last reading will always replace the first.
If you wish to review previous forehead measurement data, when
the thermometer is shut down, press the Set button for about 3
seconds until you see the symbol flicker on the screen, then
release the button.
When you press the button, you will see the number ‘1’ appear on
the screen; this means the first saved reading. The number ‘1’ will
then disappear quickly and the first saved forehead temperature
reading will appear. By pressing the button, you can go through all
the saved forehead temperature readings one by one. After
reviewing the saved readings, press the button for about 5 seconds
to shut down the thermometer.
5.4 ℃ and ℉ conversion
If you wish to convert ℃ to ℉ or ℉ to ℃, when the thermometer is
shut down, press the Set button for about 6 seconds until you see
the ‘℃’ symbol or the ‘℉’ symbol flicker on the screen, then
release the button. Press the button again and the ℃ symbol or ℉
symbol will be converted to the other.
Do not release the button when the symbol appears, but only
release it when the ‘℃’ symbol or ‘℉’ symbol appears. After
finishing conversion, press the button for about 5 seconds to
automatically save the setting and shut down the thermometer.
- 10 -
To Next Page
Loading...