Nexar Beam - Route Cable Behind Fabric; Tuck Cable into Door Seal; Connect to Power Source

Fine Tuning - How to hide the cable
nxr.cm/hide
Watch a video on how
to hide the cable
This installation method is meant only for
vehicles in which cuain airbags are NOT
installed in the window frame. This method
CANNOT be used in vehicles equipped with
cuain airbags. Hiding, tucking or installing
the wiring of your dash cam by this method
could inteere with your vehicle’s cuain
airbags and can be extremely dangerous.
If you are unsure about the location of your
vehicle’s airbags, DO NOT use this method
for the aforementioned reasons.
2 .
3 .
1 . Sit in the passenger seat.
Gently pull down the edge of the
fabric at the top of the windshield.
Use two ngers or the installation
tool to push the cable behind the
ceiling fabric.*
5 .
6 .
7 .
4 .
Inse the cable into the door’s seal.
Hide the remaining cable under the
passenger’s oor mat.
Bring the cable as close to the power
socket as possible, and connect it to
the USB charger.
Open the passenger-side door.
* If you prefer, you can use the provided
cable clips instead of placing the cable
behind the ceiling fabric.