Nexar Pro - How to hide the cable

2 .
1 .
Sit in the passenger seat.
Gently pull down the edge of the
fabric at the top of the windshield.
Fine Tuning - How to hide the cable
5 .
6 .
7 .
4 .
Inse the cable into the door’s seal.
Hide the remaining cable under the
passenger’s oor mat.
Bring the cable as close to the power
socket as possible, and connect it to the
USB charger.
Open the passenger-side door.
* If you prefer, you can use the provided
cable clips instead of placing the cable
behind the ceiling fabric.
nxr.cm/hide
Watch a video on how to hide the cable
This installation method is meant only for vehicles
in which cuain airbags are NOT installed in the
window frame. This method CANNOT be used in
vehicles equipped with cuain airbags. Hiding,
tucking or installing the wiring of your dash cam
by this method could inteere with your vehicle’s
cuain airbags and can be extremely dangerous.
If you are unsure about the location of your
vehicle’s airbags, DO NOT use this method for the
aforementioned reasons.
Use two ngers or the installation tool to
push the cable behind the ceiling fabric.*
3 .