11
pre-authorization
printer：select the printer types
No center: select if no center area
Online points：set if support online points
Points TPDU：set online points of TPDU
IC card parameter：set if support IC cards
4、Terminal key management
Key load-in：currently not available。
Key input by hand：set key by hand。
Transaction key index：set transaction key index。
TMS key index：remote download index。
5、change password
1、change administration password
2、change security password
3、reset dominating password
6、other functions
Erase transaction batch：Delete all transaction record
TMS download：Remote download
Parameter printing：Print key parameter
POS introduction：POS brief introduction
7、PC parameter download
Use computer and POS terminal for communication and parameter
setting.
8、MODEM parameter setting
Set MODEM parameter, set whether online checking、test
dialing tone, and testing time etc.
Setting on G3 by Appointed merchants’ manager
Upon getting G3 from China union pay, the appointed merchants’
manager will set G3 parameter and accredit operation rights
accordingly. (At the very first, get merchant administration
password of G3 from CUP)
Main setting：
1、under main interface, choose “7, management” option；
2、choose “4, counter staff” option；
3、all settings are valid on confirmation. Setting complete,
system will prompt whether read-in card. Parameter is valid
after read-in.
1、director revise password：
revise director password。
2、add operator：Add operators, to 30 at most.
To Next Page