Note: For best reception ensure that the side of the GPS
antenna with the word "GPS" is pointed toward the front of
the vehicle.
port. Then remove the double-sided tape from the GPS
antenna and secure the GPS antenna at the corner of the
dashboard as close to the windshield as possible. Refer to
position in the figure below.
Step 3: Run the power cable:
Using the included pry tool, pry up the edges of the interior
paneling in the vehicle so the wiring can be run underneath.
Run the power cable along the front windshield, down the
structural pillar, and across the passenger dash panel to the
cigarette lighter. Ensure that the wiring does not interfere
with your vision and will not impede your ability to drive in
any way. Plug the auxiliary power cable into the car's auxiliary
power outlet, and plug the other end of the cable into the
power input port on the Dashcam as shown in the figure
17
To Next Page
Loading...