WHY IS MY UNIT NOT TURNING ON?
FIRMWARE UPDATE INSTRUCTION
1. Remove the Micro SD card from the Dashcam. Copy / paste
or drag / drop the latest version of the firmware you downloaded
from the nexigo.com/dashcam-support into the root directory
of the Micro SD card folder on your computer. DO NOT place
it in a subfolder on the Micro SD card.
2. Insert the Micro SD card with the updated firmware into the
Dashcam when the Dashcam is powered on.
3. Once the Dashcam recognizes the Micro SD card a dialog
box will pop up asking if you want to update the system. Tap
OK, and the system will begin to update automatically.
Note: Please DO NOT power off or unplug your Dashcam while
updating the firmware. Otherwise, this will cause damage to
the operating system.
FAQ
Ensure the power cable is firmly and fully connected.
Make sure the socket of your vehicle's auxiliary power outlet
is clean and free of corrosion or other damages.
Make sure the power cable is firmly and fully seated in the
auxiliary power outlet.
Check to make sure the car fuse for the auxiliary power
outlet has not been tripped.
25
To Next Page
Loading...