Step 6: Route the rear camera cable to the front of the vehicle
and connect it to the main camera unit:
INSTALLATION NOTES
Before installing the rear camera, please thoroughly clean
the location where the rear camera is going to be mounted.
Please pre-fit and test all components before beginning
installation to ensure that all pieces will work as intended.
The provided double-sided tape CANNOT be reused. The
adhesive may not hold effectively if used more than once.
Ensure that the vehicle is off and the keys are removed from
the ignition before installation.
The majority of rear camera malfunction issues are caused by
loose or improperly connected wires. Please double-check
these first.
Step 7: Start your car and turn on the Dashcam:
Test the device to ensure that it is functioning properly and
that there is no issue with the wiring.
24
To Next Page
Loading...