Nexo GEOM1210-I System Manual

GEO M12 HARDWARE SETUP PROCEDURE Page 49/90
IMPORTANT
Ensure that bumper quick release pins are properly locked into GEO M12, and that all
AutoRig
TM
and rear pins are locked
- Lift cluster to NS-1 defined rigging height, secure cluster horizontally to prevent it from rotating;
- Secure bumper with secondary safety steel.
IMPORTANT
The requirements for secondary safety systems vary with territories. However, the
secondary safety steel MUST have a SWL equivalent or greater than that of the
rigging system.
Disassembly
- While holding GEO M12 to be dismounted, pull AutoRig
TM
on both sides and hold the side knob
(AutoRig
TM
remains in the open position).
- Remove the rear quick release pin BL820
- Unlock the GEO M12 link bar by pulling the latch.
- Remove GEO M12

Nexo GEOM1210-I Specifications

General

Brand	Nexo
Model	GEOM1210-I
Category	Stereo System
Language	English