5
b. before you sTarT...
It is very important for your safety and the safety of others that you follow
the many important safety messages in this manual and on your appli-
ance. Always read and obey all safety messages. All safety messages
will tell you what the potential hazard is, how to reduce the possibility of
injury, and what can happen if the instructions are not followed.
WARNING
* Electrical grounding is required for this range hood.
* Check with a qualified electrician if you are not sure whether the range
hood is properly grounded.
* Failure to follow electrical requirements may result in a fire.
* A fuse in the neutral or grounding circuit could result in electrical shock.
* If the hot/cold water pipe is interrupted by plastic nonmetallic gaskets or
other materials, DO NOT use for grounding.
* * DO NOT ground to a gas pipe.
READ AND SAVE THESE INSTRUCTIONS
WARNING : TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR
INJURY TO PERSONS, OBSERVE THE FOLLOWING CAREFULLY:
1) Use this unit only in the manner intended by the manufacturer. If
you have any questions, contact the distributor, importer or the
manufacturer.
2) Before servicing or cleaning the unit, switch power off at the junction
box and lock the panel door to prevent power from being switched on
accidentally. If the junction box door cannot be locked, securely fasten
a prominent warning sign to the panel door.
3) Installation work and electrical wiring must be done by qualied
person(s) in accordance with all applicable codes and standards,
including re-related construction.
4) Sufcient air is needed for proper combustion and exhausting of gases
through the ue (duct cover) of fuel burning equipment to prevent
back drafting. Follow the heating equipment manufacturer’s guidelines
and safety standards such as those published by the National Fire
Protection Association (NFPA) and the American Society for Heating,
Refrigeration and Air Conditioning Engineers (ASHRAE), and the local
code authorities.
To Next Page
