PH2
1
IMPORTANT-RETAINFORFUTUREREFERENCE-
READCAREFULLY.
Numberofpeoplerequiredtoassemble
Timetoassemble
Twopersonsarerequiredtoassemblethisitem.
2.5hours
Toolsrequired
notsupplied notsupplied
Missingparts
Homeservicetechnicians
Youcanwritetousat
Ifyouaremissinganyfixturesandfittingsforyourproduct
pleasecontactourcustomerserviceteamon03337778999
andtheywillbehappytoarrangeforareplacementtobesent
toyoufreeofcharge.
Ifyouhaveafaultwithyourproductpleasecontactour
customerserviceteamon03337778999.Ifyouhavehadthe
productfor28daysorlessyoumaybeofferedareplacement,
refundorforafullytrainedhomeservicetechniciantovisityour
hometoassessthefaultandrepairtheproductwherepossible.
Ifyouhavehadtheproductformorethan28dayswewillsend
anindependanthomeservicetechniciantoreviewandrepair
theproductwherepossibleandrecommendfurtheraction.
HomeCustomerServices
NextRetailLtd,
DesfordRoad,
Leicester,
LE194AT
ToViewourfullfurniturerangepleasevisitwww.next.co.uk
ProducedinPolandforNextRetailLtd.
2personassembly
Assemblyinstructions
COMPTONWHITECABINBED
945602
945602-2015-V1
This child’s bed conforms to BS8509:2008 + A1:2011
WARNING:
WARNING:
WARNING:
WARNING:
WARNING:
WARNINGS
Do’s
Don’ts
Do not place this child’s bed near heat sources,
windows and other furniture
Do not use this child’s bed if any part is broken,
torn or missing
Assembly by adult only
Once assembled this bed is not designed to be
disassembled and reassembled
Children are likely to play, bounce, jump and climb on beds,
therefore the child’s bed should not be placed too close to
other furniture or windows, blind cords, curtain pulls or other
strings or cords and should be placed either tight to any wall
or have a gap of 300mm between the wall and the side of the
bed
This size of the mattress to be used with the child’s bed is
900mm x1900mm
This Child’s bed is intended for children above 4 years old
Not suitable for children under 4 years (junior
beds only)
When you are ready to start, make sure that you have the
right tools and plenty of space
Due to the size of the product we recommend that it is
assembled in the room intended for use
Unwrap all packaging materials and place the components on
a clean surface to protect it from damage,
We recommend that the packaging is used to protect the
surfaces during assembly
Carefully check that you have all the parts before beginning
assembly
Please periodically check all fittings and re-tighten as
necessary
To clean your item, wipe with soft cloth slightly dampened with
water. Then buff with a dry clean cloth
Routinely check that the fittings are secure and tighten any
fittings using the appropriate tools
If any parts are missing please contact Next to obtain
replacements. Under no circumstances should missing parts
or hardware be substituted unless obtained from Next
Do not drag or pull your furniture
Do not use silicone based furniture polish. Silicone in furniture
polishes can break down the lacquer finish
Do not stand or jump on this product