EN
1 - CARATTERISTICHE DEL PRODOTTO
1.1 DESCRIZIONE
Multi-frequency (433.92 MHz or 868 MHz) remote control with 4-zone and duplicator
function included.
It’s possible to duplicate remotes with single code or rolling code type 1, rrolling code
type 2 (brands BFT, V2 and FAAC) or make copies of already “cloned” remote controls,
see paragraph No.3
1.2 TECHNICAL DATA
Power supply Battery type CR2032
RF frequency 433.92MHz / 868 MHz
Channels 4
Dimensions 71x36x8 mm
2 - USE OF REMOTE CONTROL
The remote control can be used by programming it directly on compatible Nexta Tech receivers or it can be used to
duplicate existing transmitters.
DIRECT PROGRAMMING ON COMPATIBLE RECEIVERS
The remote control can be associated with any Nexta Tech control unit, see the receiver control unit manual.
COPY FUNCTION
The radio control has the function of duplication towards the transmitters present on the market with xed code or rolling
compatible type. See compatibility table in paragraph 4.
To duplicate a key of an existing transmitter:
1- carry out the procedure in paragraph 3 based on the original remote control “
2- insert the cloned key of the “copier remote control” in the receiver memory. The insertion can be done “manually” with
access to the receiving unit or, if the transmitter allows it, with a procedure on the “copier radio control”, see paragraph 4.
CAUTION:
- Each button of the remote control can have a different function. Therefore it is possible to duplicate up to 4 remote
controls using a single copier
8
To Next Page
Loading...